cnogueral
Level 1
Level 1
Member since ‎07-17-2017
‎03-04-2020

User Statistics

  • 33 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies
Certifications

User Activity

Hello I need to upgrade the CIMC for a PI-UCS-APL-K9 but i don´t found the drivers or utility for this. I woud lie to know if i can upgrade this with the huu utility for ucs 220m4, or what could be the correct way to do that. Thank you
A customer is performing the ipv6 implementation. the wlc is currently being configured, the ipv6 address was set in the management interface, this ip responds ping from the core, but from another vlan in the network does not respond ping. I would li...
I have a client that has two wlc 2504. The configuration was made to be in HA SKU N + 1. At the moment of connecting both in the network it is observed that the mobility group looks good and both wlc are seen. But at the time of restarting the primar...
The client has installed the ise nodes with VM similar to the 3595 appliance. Due to an inconvenience that arose, it was necessary to review a support bundle and there were some CPU alerts, due to this the recommendation to enable hyperthreading to a...
The integration of ISE with Aruba is being carried out. ISE is in version 2.2 and is being integrated with an IAP that is in 8.5 The configuration was done by guiding us with the following document, where each step is explained well.https://www.cisco...
Community Statistics
Member Since ‎07-17-2017 09:00 AM
Date Last Visited ‎03-04-2020 12:17 AM
Posts 33
Helpful Votes Given To