James,
Based on the below YANG model, you may want to try network_address since you're adding a subnet as opposed to ipv4-host. Request below:
curl -X 'PATCH' \
'https://<IP_ADDRESS>:443/restconf/data/Cisco-IOS-XE-native:native/object-group/Cisco...
Hi there,
show standby
CLI is IOS XE CLI. You mentioned you are using a Nexus 9000 so you would need to use
show hsrp
instead. Example:
N7700-1-WAN# show hsrp brief
*:IPv6 group #:group belongs to a bundle
P indicates confi...
Hi there,
I believe you are looking for the Verified Scalability Guide for NXOS 7.0(3)I7(6) which states how many HSRP Groups can be instantiated on a given switch.
Look under Table 13. Unicast Routing Verified Scalability Limits:
Hope that helps...
I could not quite place the hardware's exact release dates, but I can tell you this:
1. N9K-C9508-FM-E2 was released around the same time as NX-OS 9.2(1), which has an FCS date of 18-Jul-2018
2. N9K-X97160YC-EX was released around the same time as NX...
Mark,
No worries, and you are most welcome!
I did go back to my DNAC and my test C9K I was using for this and noticed what you are pointing out: I have 10 interfaces UP/UP, but my API JSON response only contains 5 links.
I realize DNAC is responding ...