Cisco Community
English
Register
Great changes are coming to Cisco Community in July. LEARN MORE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
johnd2310
‎05-01-2022

Collaborator
Recent Badges
Awards
Recent Badges
See all
150 Accepted Solution
600 Helpful Vote
100 Helpful Vote
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
30 Helpful Vote
300 Helpful Vote
10 Helpful Vote
Stats
Member since ‎06-30-2005
1373
Posts
1004
Helpful
169
Solutions

Re: ZBF with NAT on IOS XE

Created by in VPN
01-12-2022
01-12-2022
Hi,Could be that zbf cannot inspect or does not understand the registration traffic. Can you try add...

Re: timeout tftp transfert to flash (C2960X-24TS-LL + 48TS-LL)

Created by in Network Management
08-23-2021
08-23-2021
Hi, Is the configuration identical on all the switches? Is the config on the working switches identi...

Re: Avaya 9608 on Cisco 3650 being forced on Data VLAN

Created by in Switching
07-07-2021
07-07-2021
Hi, What is you switch port config. Was the other switch you tested the phone on a 3650 running 16.1...

Re: Putty 0.60 SSH issue with 1101 - Verison 17

Created by in Network Management
05-14-2021
05-14-2021
Hi,There could be a change in the default ssh cipher in the 17.x code and putty 0.60 does not suppor...

Re: Getting ip address from second ssid

Created by in Wireless
03-31-2021
03-31-2021
Hi,Yes, what you are proposing should work. Your access points will tunnel both vlans to the control...

Re: Securing TACACS Key

Created by in Switching
03-29-2021
03-29-2021
Hi, What switch model and what ios code are you running? If you are running Cisco IOS XE Gibraltar 1...

Re: can configuring ipv6 address on already configured and functional ipv4 address will cause service interruption ?

Created by in IPv6
03-28-2021
03-28-2021
Hi, If you are configuring ipv6 address on an interface running ipv4, then there should be impact to...

Re: Block SNMP and NTP

Created by in Switching
03-05-2021
03-05-2021
Hi, To disable NTP on Interfaces use the interface command "ntp disable". You would use this command...

Re: SFP-10G-LR

Created by in Optics and Optical Networking
03-04-2021
03-04-2021
Hi,According to the following doc, that sfp works with single mode fibre.https://www.cisco.com/c/en/...

Re: CISCO ASA 5508-X FirePOWER Confusion

Created by in Network Management
02-25-2021
02-25-2021
Hi,What is the ip address of your PC?The gateway address of the firepower module cannot be the manag...

Re: ASA - LAN dont recieve internet - possible NAT issue

Created by in Network Security
02-25-2021
02-25-2021
Hi, Can you configure your outside interface as follows "ip address dhcp setroute" ThanksJohn

Re: CISCO ASA 5508-X FirePOWER Confusion

Created by in Network Management
02-24-2021
02-24-2021
Hi,1.) You do not need to change the management interface.2.) There is no relationship between your ...

Re: Sudden Increase in ARP Traffic - ARP Inspection Limit Breaches

Created by in Switching
02-24-2021
02-24-2021
Hi, Are your access points autonomous or are they managed by a controller. If your wireless is contr...

Re: What ASDM version is compatible with ASA software version asa984-32-smp-k8.bin

Created by in Network Security
02-24-2021
02-24-2021
Hi,From that chart, ASDM 7.12(1) is compatible with the software you are upgrading to. ThanksJohn

Re: ASA 5506 Smartnet Solution

Created by in Smart Net Total Care Portal and Collector Discussions
02-24-2021
02-24-2021
Hi, You will need to buy smartnet for the device to get access to software updates. ThanksJohn
Public Statistics
Date Registered ‎06-30-2005 01:23 AM
Date Last Visited ‎05-01-2022 12:58 AM
Total Messages Posted 1,373
Total Helpful Votes Received 1004
Helpful Votes Given To
See all >
Helpful Votes From