About Manesh Rajan

Manesh Rajan · 05-31-2022

Hi folks, I have two switches cisco WS-C4507+E with WS-X45-SUP7-E Sup engines installed in slot 3. I want to build a supervisor engine redundancy using WS-X45-SUP8-E (slot 4). Both switches are in standalone mode only (not in VSS). Once this upgrad...

Manesh Rajan · 06-07-2014

As far as i know both technologies makes physical switch into a single logical one. Does anyone know what is the exact difference in both technologies? i appreciate your help. Thanks

Manesh Rajan · 02-27-2012

Hi,I have a problem with Wireless Control System (WCS v7) WCS-STANDARD-K9 and installed with WCS-PLUS-100 (installed two licenses) so total licensed installed is for 200 Acesspoint's in WCS. I have 149 AP's connected to WCS and its shows error " Sys...

Manesh Rajan · 10-14-2011

If i have a ASA in my network, FWSM in 6509E switch ? what is the use of both device? only one device is required right? or i can use that product if i start data center ?

Manesh Rajan · 10-03-2011

Hi,Anybody please describe why WCS shows Load Threshold Violation Error??? Thanks

Manesh Rajan · 10-10-2014

Hi Barryfowles,Could you share some notes that you used to install 5670WLC in HA mode ?Thanks in advance ---Manesh

Manesh Rajan · 06-07-2014

Dear Leo,Thanks for the reply. Is there any method like one of the control plane will be active and all the data plane is in forwarding state in stacking technology?

Manesh Rajan · 07-31-2012

I think that interface is configured for non negotiate, so its better to change it toSwitchport mode accessSwitchport access vlan 1no shut

Manesh Rajan · 01-04-2012

Hi Marvin,Can u explain what would be the basic reason to behave an ASA too slow and also CPU utilization is low? i have a same problem. ASA is enabled with basic thread detection and for the internal network UDP & TCP ports >1024 is allowed and equa...

Manesh Rajan · 10-16-2011

Hi Jennifer, FWSM is directly connected to switch backplane.. How can i make use of FWSM on two 6509E chassis & WiSM card? WLAN Clients connect to network using LWAP Thanks..

Member Since	‎11-15-2010 11:59 PM
Date Last Visited	‎04-03-2024 12:05 AM
Posts	36
Total Helpful Votes Received	9

User Statistics

User Activity

Two different SUP Engine models in a Single Chassis Switch

Difference in Stackwise & VSS?

Wireless Control System Error Msgs.

Need clarification on ASA & FWSM..

Load Threshold Violation Error

Hi Barryfowles,Could you

Dear Leo,Thanks for the reply

Help with 6506-E Config

Firewall ASA is very slow

Re: Need clarification on ASA & FWSM..