I wanted to see if anyone had suggestions on the best way to configure SIP Options Pings. Typically I would configure them per dial-peer. However, I really want to do it per destination IP address. I do not want a SIP Options ping for every single ...
I cannot for the life of me figure out how to let floating extensions access their voicemail from any phone for initial setup. It keeps telling me "For security reason initial access to this voicemail box must be done from the primary extension". S...
I really just need pointed to the right documentation. I've searched and I can't find it even though I know I've done this before.Setup:SIP Trunk --> 2821 --> PBXThe PBX is not a call manager. We are using the 2821 basically as a SBC. So SIP to SI...
I have successfully gotten the SPA525G to connect to my ASA 5510 via SSL VPN. However it seems to be idle disconnecting. I've disabled idle disconnect in the VPN Group Policy but that didn't do the trick. Is there something on the phone I need to ...
Here is what I propose as a feature request. Allow multiple sip-server entries under the sip-ua. Then allow the setting of the options ping per sip-server. Then if the option ping fails all dial-peers with that sip-server destination would then bus...
Yes, I know all of that. What I really want to know: If I have 6 dial-peers all pointing to the same target. All 6 have the Out of Dialog option ping set. Does the CUBE send out 6 pings, or just 1?
Yes I did not change anything and it works properly now from what I can tell. Since we have only come across 4 numbers where the codec mismatches it doesn't pop up very often so it is hard to catch using a sh sccp connections. I am going to leave t...
