MUHAMMAD SHAHEEN

Yes you can.Just make sure you change the port to be "switchport mode trunk " on both sides and use ...

Ensure IP ROUTING is enabled. the default is disabled. then it should work.If you don't want IP ROUN...

First of all many thanks for this very helpful link it has a lot of information.I have read this doc...

ip http server is not missing and is there. The first sign on process works fine and I get this :+++...

Have done this already, now the web console does not work even it I reload the switch using the old ...

Hi all,I have a C2950 which had c2950-i6q4l2-mz.121-11.EA1.bin , I was able use web console. I have ...

I think there is nothing wrong with your original config. Just disable the access list on both end i...

I normally use Show ver, that gives enough summarised information about H/W and S/W.If you want more...

Hi,Creating a VLAN will only create VLANs on the switch. Each port need to subscribe to a particular...

I had similar problem on GBIC port on C3550. I have 2x C3550 connected via GBIC. One of them had thi...

Hi All,I have 2 Cisco routers and want to setup a lab at home. I also have 2 DTE cables to connect t...

When you want to download IOS, it will tell you how much memory and flash is required in the switch ...

I came across sometinh similar, but I was able to add a static route to get this working.You can try...

Hi,In your config, try to remove the following lineip route 192.168.5.0 255.255.255.0 FastEthernet0/...