Hi,It is understood that sub-50 ms ERPS convergence can be achieved with certain HW/SW combinations.1) What are the platforms supported and what FW/SW has this been tested with ?any results that can be shared?2) Link failure detection in GigE on Cop...
Hi,It is understood that sub-50 ms ERPS convergence can be achieved with certain HW/SW combinations.1) What are the platforms supported (and with what FW/SW) has this been tested ?any results that can be shared?2) Link failure detection in GigE on C...
Trying to retrieve SNMP IpAddrTable (OID =1.3.6.1.2.1.4.20) regardless of VRF configuration. MIBWALK gives all the unique VRF specific (+ default) IP addresses,however fails to identify overlapping IPs.See output below.============================...
Tring to retrieve SNMP IpAddrTable (OID =1.3.6.1.2.1.4.20) regardless of VRF configuration. MIBWALK gives all the unique VRF specific (+ default) IP addresses,however fails to identify overlapping IPs.See output below.================================...
Hi,NSSA area border router is supposed to translate LSAs from type 7 to type 5.On the other hand only ASBR can generate type 5 LSA. In the case of NSSA, is it correct to assume that NSSA ABR must also necessarily be an ASBR?Thanks,rsg.
Hello Gerald,
While this being one of the easiest and most practical for WAN bandwidth testing I would like to emphasize that it can be CPU intensive.
What i have seen is as soon as tried with size18000/timeout 0 CPU jumped to over 50% of an aggregat...
Hi,Having the same bridge priority is not a requirement to maintain vPC consistency.Even if you had the highest bridge priority in the secondary, your vPC primary would forward BPDUs in vPC domain. quoted from "Cisco NX-OS Virtual PortChannel: Fundam...
Thanks Nagendra for confirmation of this point. Jon/Marikakis: thanks for your comments as well.So it looks like that the NSSA ABR also acts as an ASBR. However, I couldn't find this information in any document other than the RFC 1587, which made me ...
