About fabio.marino

fabio.marino · 10-31-2015

Good Morning All, I have a quick question. Concept of native vlan and dtp is clear. No need of link to both concept. Target of the test -> Test the behaviour of Native Vlan. Create untagged traffic and check if it is carried over the native vlan. Te...

fabio.marino · 05-07-2015

Hi, I have a quick one. On the config guide of the nexus 7k you can read the following You can configure the router ID. By default, Cisco NX-OS sets the router ID to the IPv4 address of a loopback interface on the router. If no loopback interface is ...

fabio.marino · 02-23-2015

Hi all,I have a problem and I really do not know the reason.Simple scenario. I need to configure ospf into a ASR1004 router.Here the command vrf definition TEST-02 ! address-family ipv4 exit-address-family!!interface Loopback25 description TEST-02vrf...

fabio.marino · 02-16-2015

Hallo All, I would like to translate an extend access list in a prefix list. ip access-list extended x_to_ypermit ip 1.1.1.1 0.0.1.255 anydeny ip any host 3.3.3.3 Any hint? Thanks!!!

fabio.marino · 11-19-2014

Hi All, Simple question. I have two switches connected via 1Gb link. They are running rapid pvstp. The layer 2 topology is the one below depicted.I now need to upgrade the connection with a 10Gb link, keeping the 1 Gb link for backup. My question is:...

fabio.marino · 10-31-2015

I just need a confirmation that the lab should work. I investigate offline. Cheers, Fabio.

fabio.marino · 10-31-2015

Hi Jon, Thanks. SVI have been created as stated before. L3 devices yes. Ping is working between R1 and R2. Configuration should be also ok. Wireshark is showing me the arp request leaving the R3 but no reply. It looks like that R3 has a different b...

fabio.marino · 05-07-2015

Hi Richard,I agree, then I think I mixed up the answers and I mixed up with ospf concept as well.In briefI will shutdown the interface so of course I am exepecting the shutdown of the bgp neighboprshipThe BGP process will never reset in my specific ...

fabio.marino · 05-07-2015

Hiperfect..then I have to expect a bgp reset because this ip is used for peering with BGP neighbors..... Thanks!!

fabio.marino · 05-07-2015

Hi, Thank you for the reply but it is not clear.You statedThe 7K should keep using the router-id it has been configured with, i.e. the interface xyz, because you have "pinned it". Again, what will happen when the interface xyz is down? Which router-i...

Member Since	‎09-20-2010 02:40 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	190
Total Helpful Votes Received	5

User Statistics

User Activity

Tagged and untagged traffic (802.1q)

BGP Router id in nexus 7k.

cisco ASR1004 error %VRF specified does not match existing router

change an extend access list in a prefix list

Rapid pvstp+

I just need a confirmation

Hi Jon,

Hi Richard,I agree, then I

Hiperfect..then I have to

Hi, Thank you for the reply