About haydavis

haydavis · 05-27-2020

Same here. When logging into Sandbox lab i get "Login failed". and prompted for username / password. I enter again the username password from the email "Your Cisco DevNet Sandbox Lab is Ready and get "Login failed".pls help. !sudo /usr/sbin/openco...

haydavis · 07-29-2018

Routes in route table not sent to bgp peer at 10.0.79.70 but only two subnets sent. Need to send them all including default route. <hostname removed>#sh ip bgp nei 10.0.79.70 advBGP table version is 1840, local router ID is 172.16.159.17Status cod...

haydavis · 06-26-2017

Unable to remove the load network config file via tftp. I find this in the show version on a 3650. The switch is prepared for IOS upgrade but I found a tftp config file in the show ver. I dont want to reload the switch as I would rather load the ...

haydavis · 03-23-2016

Looking for assistance to get started configuring WAAS on a ISR4351 with built in SM controller. I can not seem to find a interface to setup. I tried playing with Service Engine interface but not getting anywhere. Interface IP-Address...

haydavis · 05-11-2015

I have a router connected to MPLS network for Primary access and EZVPN for back. MPLS and BGP look stable and routing table is stable. Telnet/Ping access thorugh MPLS to router is good but can not reach anything on the LAN side of the router. Not ev...

haydavis · 11-29-2021

This fixes GUI issue for me dude. from cli try: request nms all restart

haydavis · 09-11-2020

Very helpful thx. I also had to add clock timezone clock timezone GMT 0 0clock calendar-valid

haydavis · 05-27-2020

haydavis · 08-02-2018

Found the problem. Route map inbound from PE had this: set community no-export additive This command was telling BGP not to forward these subnets out another EBG process. Removed no-export additive and works find. Thanks all.

haydavis · 07-29-2018

My router is receiving updates from layer 3 switch but only sending connected subnets and not any subnets from routing table. Gig0/1 is the port connected to layer 3 3850 switch G0/2 is coneected to a MPLS PE router. pbserv-uschi300-re01#sh ip b...

Member Since	‎04-04-2005 07:10 AM
Date Last Visited	‎03-02-2023 09:07 AM
Posts	29
Total Helpful Votes Received	5

User Statistics

User Activity

DevNet VPN Login Failed Openclient Linux

BGP not Advertising between Neighbors

SHOW VER has a network config file load from tftp. Would like to load from Flash.

SM-SRE-910-K9 ISR4351 Built-In SM controller

EZVPN Connection Down causes Black Hole while BGP to MPLS is established and updating

Re: CSCvu93723 - vManage 20.3, UI error because vmanage as app-server

Re: nvram last config not displaying

Re: Cisco DevNet Sandbox Lab VPN login failed

Re: BGP not Advertising between Neighbors

Re: BGP not Advertising between Neighbors