All,I wanted to load the factory defaults for my 881W so I could get a clean start. Following this Cisco article:http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_tech_note09186a00802017a1.shtmlI used the following commands while telnet...

All,I have an integrated 881W with a built in 801 access point.  I'm interested in increasing the range of my AP.  I'm interested in considering any configuration changes while still maintaining support for N.  I've included a copy of my running conf...

I have two basic problems and could use help1.)  My neighbors are using the same wireless channels as I am (6 + 10).  I would imagine that I should change my channels to avoid contention/congestion.                    My wireless networks (SSIDs Fran...

All,I have a wireless client (MAC Address:  c43d.c7a9.4917) that is connecting to my wireless VLAN at a slower linkrate (56Mbps) than is desired.  Thewireless client is 802.11n version 2.0 capable, which means that it is capable at connecting at a hi...

All,I need to update my Cisco 881W config to allow port forwarding FROM the Internet TO the following inside device as follows:IP Address:  192.168.1.254Protocol:  TCP/UDPPort: 5001This device is a Slingbox Pro-HD and I want to be able to view it fro...