what is the version of code running - You can try either below method that should work for you :
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/ts/guide/trouble.html
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/3-1-1/s...
check the below thread to find out more about what caused the issue :
https://community.cisco.com/t5/cisco-bug-discussions/punt-inject-5-drop-punt-cause-punt-cause-policer-drop-packet/td-p/3959555
Hello support
i am not sure iam the one who facing the issue, but i checked same time on mobile i see the same time
i am based at +0:00 BST - around 8 am to 9 am between the community site losing the connection in the middle of my comments, and a...
Looking to deploy in production environment, Default Catalyst 9300 ship with Everest-16.6.3 ED.
what is the difference here - which one got more advantage, i know Everest is the answer, if that is answer Why Fuji ?
Change the Router from controller to Normal
# controller-mode disable
guide help you :
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/sdwan-xe-gs-book/install-upgrade-17-2-later.html
If you using FTD and FMC, then you need to use that configuration to work.
I was testing FTD 7.2.5 and 7.3 ( some of the you can directly configure using FMC) - i was not sure if the WCCP in that area, worth checking in the release notes.
https://www...
as i suggest good to have Physical diagram to help better along with what logs you have collected when the issueoccur.
This is not like simple steps to offer solution, this required clear understand how your Layer2 connected, where the problem persis...