what is the version of code running - You can try either below method that should work for you :
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/ts/guide/trouble.html
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/3-1-1/s...
check the below thread to find out more about what caused the issue :
https://community.cisco.com/t5/cisco-bug-discussions/punt-inject-5-drop-punt-cause-punt-cause-policer-drop-packet/td-p/3959555
Hello support
i am not sure iam the one who facing the issue, but i checked same time on mobile i see the same time
i am based at +0:00 BST - around 8 am to 9 am between the community site losing the connection in the middle of my comments, and a...
Looking to deploy in production environment, Default Catalyst 9300 ship with Everest-16.6.3 ED.
what is the difference here - which one got more advantage, i know Everest is the answer, if that is answer Why Fuji ?
Make sure CDP / LLDP enabled where required on the switch and make sure CDPv2 enable :
example : (if this is cat 9K switches ?) - make sure AP got enough POE
#show cdpGlobal CDP information:Sending CDP packets every 60 secondsSending a holdtime value...
As Router it can only do the routing and port-forwarding based on the IP
personally i suggest all the DDNS need to point to same public IP of outside and making different A entries on the DNS.
Example
mail.bb.com - 202..202.202.1 ( 10.10.10.20)
...
High level Cisco do not have ADVPN (this is from Fortinet as i remember correctly)
cisco uses DMVPN / GETvPN - so on that you get more information on the Google
its all depends on the requirement and design one over other, each one have pros and co...
Can you post full config of interface -
Do you have under interface allow-service all (this overrides all other config)
check the below guide what ports used :
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/sdwan-xe-gs-book/cisco-...