Hi floks.
In some advice please. we running ACI multipod between to Data Centers. we classified these DCs as Primary and Secondary due to legacy setup prior to going into ACI deployment. The ACI deployment is in Network Centric.
we have APIC 2xAPIC i...
Hi.
to fix this go to Deployment -->General Setting -- untick the PxGrid prob and save. than after 5 min go back and tick this PxGrid prob. it will fix the issue you noted earlier java.lang.NullPointerException
I was hitting this bug ISE versi...
Hi folks.
we hit a APIC bug CSCvu62127. the symptoms were; Upon fabric discovery, we are receiving a fault code F3031
TAC ask to provide,
show controller
acidiag fnvread
acidiag avread
acidiag rvread
moquery -c faultInst -f 'fault.Inst.code=...
I was testing FMC 6.5 with FTD 6.5. I need to set up an tcp advanced option by pass. below command does not work as we use them in ASA.
class-map tcp_bypass
match access-list $TCP_Bypass
policy-map tcp_bypass_policy
class tcp_bypass
set connection ra...
Hey @Aref Alsouqi I have found this Link it could be helpful for the Robert. But your provided link is also a good link too. Hope this provide link will be helpful.
you firewall configuration are solid. I think the issue is with the routing. In your provided output
#pkts encaps: 80, #pkts encrypt: 80, #pkts digest: 80
#pkts decaps: 0, #pkts decrypt: 0, #pkts verify: 0
The firewall is able to encap and sent the t...
There is difference between the command show vpn-session summary and show crypto ipsec stats.
show vpn-session summary:
This command provides a summary of VPN sessions currently active on the Cisco ASA.It includes information such as the total number...
FMCv300 is supported on Azure Cloud started from version 6.4 Here
Is migration from FMC2500 to FMCv300 supported? Here this link already mentioned a similar ask as your requirment.
for the recommended upgrade/migration path the Gold star version is...
we have few different FTD running in production with HA pair. when I have to make any changes on each HA-pair devices with flex-config we used dedicated flex-config for each HA-pair FTD.In short keep a dedicated flex-config for each unit do not mix-m...