Hi floks.
In some advice please. we running ACI multipod between to Data Centers. we classified these DCs as Primary and Secondary due to legacy setup prior to going into ACI deployment. The ACI deployment is in Network Centric.
we have APIC 2xAPIC i...
Hi.
to fix this go to Deployment -->General Setting -- untick the PxGrid prob and save. than after 5 min go back and tick this PxGrid prob. it will fix the issue you noted earlier java.lang.NullPointerException
I was hitting this bug ISE versi...
Hi folks.
we hit a APIC bug CSCvu62127. the symptoms were; Upon fabric discovery, we are receiving a fault code F3031
TAC ask to provide,
show controller
acidiag fnvread
acidiag avread
acidiag rvread
moquery -c faultInst -f 'fault.Inst.code=...
I was testing FMC 6.5 with FTD 6.5. I need to set up an tcp advanced option by pass. below command does not work as we use them in ASA.
class-map tcp_bypass
match access-list $TCP_Bypass
policy-map tcp_bypass_policy
class tcp_bypass
set connection ra...
Hi. To configure the time or time zone on ASA firewall please follow these configurations.
enable
configure terminal
#Replace "EST" with your appropriate time zone abbreviation, and "-5" with the appropriate offset from UTC.#
clock timezone EST -5
#S...
you need to apply the nat rule and hairpin configuration.
same-security-traffic permit intra-interface, change the priority of nat move your anyconnect nat rule on very top if using ASDM and if CLI using 1
nat (outside,outside) 1 source dynam...
you are doing a LOCAL http authencation in that case for priv-5 you can narrow it down with giving the following configurations.
I have not tested these configuration they might work or might not. But as an example below something like this might wor...