Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About bhackbarth
Stats
Member since
06-21-2012
42
Posts
5
Helpful
2
Solutions
03-11-2013
Hello,Make sure the clients in VLANs 10,20,30, and 50 are using
192.168.1.254 as their default gatew...
Created by
bhackbarth
in Small Business Switches
02-08-2013
02-08-2013
Hello, are you able to communicate with the switch through the RS232
console port? If so, why not tr...
Created by
bhackbarth
in Small Business Switches
02-07-2013
02-07-2013
Hola senor, el LED parpadeara cuando DHCP esta configurado dentro del
switch y la IP address no es r...
01-27-2013
So your Juniper is 192.168.1.1 and is the default gateway, and you want
the switch to take over as t...
01-23-2013
The dual firmware image feature starts on the 300 series. Good
information on the firmware backup fr...
Created by
bhackbarth
in Small Business Switches
01-10-2013
01-10-2013
If the front panel started to blink after you held the button for 30
seconds or more, that's a good ...
Created by
bhackbarth
in Small Business Switches
01-06-2013
01-06-2013
Hi Richard, Definitely set G3 and G4 as Trunk ports if there are
multiple VLANs coming in and out th...
Created by
bhackbarth
in Small Business Switches
01-03-2013
01-03-2013
A trunk port is only helpful when you have tags identifying which VLAN
the traffic is supposed to be...
12-25-2012
Everything Tom said, and depending on what FW version your sonicwall is
running, you can do 802.1q t...
Created by
bhackbarth
in Small Business Switches
12-22-2012
12-22-2012
Hi Adam, Could you do another factory reset, then do a ping -tand let it
run for 10 minutes or more ...
12-22-2012
Hello, I have SG300-28Ps as the PSE's for my IP telephone system. The
phones are tagging their voice...
Created by
bhackbarth
in Small Business Switches
12-04-2012
12-04-2012
I use PuTTY to SSH into Cisco switches regularly. Today I ran into the
message 'incoming packet was ...
11-19-2012
You would have been better off to start a new thread rather than
resurrect this one at two years old...
11-19-2012
Thanks Tom, Since my voice vlan is still the native VLAN at this point,
I can turn off auto smartpor...
Public Statistics
| Date Registered | 06-21-2012 02:07 PM |
| Date Last Visited | 08-18-2017 04:00 AM |
| Total Messages Posted | 42 |
| Total Helpful Votes Received | 5 |
