It is the old way, I certainly agree with that. LLDP's draft was finalized in 2005 so implementation...

I had issues getting LLDP to work with that switch (the 28P) with Mitel 5330 and 5340 sets. The Cisc...

It's definitely not just a straight firmware problem; I've run every version of firmware since 1.0.0...

Very good info! Thanks for this.

Realize that the 3560 isn't a small business product and is supported by TAC, not the small business...

Thanks Thomas and Nagaraja for writing. In response to Thomas' question about the VLAN1 address, I w...

Thomas is spot on this one. Firmware versions 1.1.1.8 and below have a MAC table bug that causes mul...

There have been some reports lately that certain browsers may cause issues when upgrading, namely Ch...

Truly odd. Obviously STP isn't disabling. After upgrading, did you apply factory defaults, then turn...

Are you running software version 3.0.2.0? If not, upgrade and try again.

The SGE2010P doesn't have CLI, so there's no way you will be able to enter those commands. However i...

I recently started upgrading our small business line to image 1.2.5.70. This includes an SG300-20 an...