Hi team,I can´t make that access-lists works with FQDN.when i do show access-list the output show (unresolved) any (inactive) ASA CODE is Cisco Adaptive Security Appliance Software Version 9.12(4)38here is the configacl,asa,fqdnasa dns domain-lookup...
Hi we are trying to configure PBR with VTI as next-hop interface or ip address, but with no luck.
we see that traffic is matching the PBR and ACL and indeed the traffic is returned according to the statistics of show crypto ipse sa peer x.x.x.x but...
Hi team, as title say,cme-srst: Registered, Not In Use. each time we reboot the router this is preventing the phones can register again when the router reboot, when we re issue the command no max-ephones and max-ephones everything works again and the...
Hi team,We are having issues with the AP 1602e, this is the scenario.we have two WLC one 2504 with the primary version 8.5.140.0 and secondary with the version 8.3.150.0 and the second WLC 5508 with the primary version 8.5.140.0 and secondary with th...
Hi experts,I am managing 3 WLC:1- WLC 2112 - code version 7.0.235.02- WLC 2112 - code version 7.0.235.03- WLC 5508 - code version 7.6.130.0 (new purchase)Is possible to group this 3 WLCs in one Mobility Group
Thanks, After after reading in depth, fqdn is not resolved until the access list is applied to an interface.and i solve my needs with dynamic split tunnel according to this document Cisco AnyConnect Secure Mobility Client Administrator Guide, Release...
the problem was the command ip verify configured in tunnel 10 interface
IOSFW1#show running-config interface tunnel 10Building configuration...Current configuration : 327 bytes!interface Tunnel10description VPN1ip address 169.254.255.2 255.255.255.2...
Hi thanks for the replay,.
what is the device you using to configure ?
Cisco C881-K9 - IOS 15.4(1r)T2 with advsecurity
what is the configuration of vlan 1?
IOSFW1#show running-config interface vlan 1Building configuration...
Current configuration :...
Hi THanks for the replay,Yes, we are saving the config, yes when we reboot the router and execute the command show telephony-service license, the status of cme-srst is registered, Not in use, when we execute the command no max-ephones and then max-ep...
