Just wondering what the reason for this is. Why not just set the 1 Mbps rate as mandatory, and the rest of the 802.11b rates (2, 5.5, 11) as supported?   Is there a benefit for setting multiple rates as mandatory instead of just the lowest rate? I am thinking of getting rid of all 802.11b rates to increase throughput since we don't have any 802.11b clients. ... View more

I have an AP joined to a Cisco WLC 2504 controller. I'm running a few debug commands on the AP directly, but the idle timeout period is way too short. Is there a way to change the SSH idle timeout either temporarily or permanently on the AP? ... View more

This document shows a list of IP protocols that are possible in the protocol field of the IPv4 header. ICMP is protocol 1, TCP is 6, and UD is 17. If I use a "permit ip any any" in a Cisco extended ACL, what protocol(s) are included in the permit statement?   SWITCH(config-ext-nacl)#permit ? <0-255> An IP protocol number ahp Authentication Header Protocol eigrp Cisco's EIGRP routing protocol esp Encapsulation Security Payload gre Cisco's GRE tunneling icmp Internet Control Message Protocol igmp Internet Gateway Message Protocol ip Any Internet Protocol ipinip IP in IP tunneling nos KA9Q NOS compatible IP over IP tunneling ospf OSPF routing protocol pcp Payload Compression Protocol pim Protocol Independent Multicast tcp Transmission Control Protocol udp User Datagram Protocol SWITCH(config-ext-nacl)# ... View more