Greetings,I have a new Firepower 2110 firewall, it was starting in Rommon mode, I had tried to boot from tftp successfully.But after which it restarts automatically.Attached is the output. It seems it is going under some error. Below is the message i...
Greetings,I have this new ISR-4451-X-VSEC/K9 router. And I need to configure Virtual WLC. No licenses are installed, Router has Ipbase software. Can anybody suggest me a guide to configure this hardware and start WLC.I have attached show run and rout...
Greetings,I have a 9407 and 4507 core switch, I need to make redundancy between them. As VSS is not possible I have tried HSRP with below configurations. HSRP Redundancy is working fine but issue seems to be with the uplinks from access switch. Seems...
Greetings,I have a Call manager CUCM installed with version 11.5But in my smart account I have 12.X version licenses.Is there any way we can install this licenses on 11.5 Call Manager without upgrading it.Kind Regards,
Greetings,I have Activated Smart licenses to Call Manager from smart account registration.I have noticed that it is not utilizing BE6000 Starter Bundle UWL 35 license at all. Secondly I have notices it is also not utilizing Basic Messaging User (Voic...
Hi Rich,Thank you for your reply,I have tried to connect UCS-E180D-M3/K9 with VGA monitor. This are the message popping on the screen. Seems like there is no Esxi is installed. Should i access it with Cimc IP and install esxi and try my luck. And wha...
Greetings,Appreciate your reply,I have noticed in the router, that there is a SM sub slot for UCSE, Can we use this server for installing wireless controller on it.UCS-E180D-M3/K9I have tried to login to this module but I had no luck in accessing the...
Thank you for your reply,Is there a way to confirm that this router support vWLC with current hardware and licenses mentioned in the pdf.Or is there a way to contact cisco and confirm the solution. Thanks in advance.
