Hi Community,
We will have a disaster recovery (DR) test of an ACI Multi-pod DC location represented by a single POD, which will be isolated from the rest of the ACI fabric.- There will be a single APIC cluster member in the isolated pod, which is go...
Hi Community,
Hi Community,
Is it possible to use Intra-EPG isolation in ACI L2 BD/EPG where the default gateway is on an external Firewall and not on ACI?
EPG/BD is basically a Layer 2 (bridged) replacement for the VLANSegmentation is done on a phys...
Hi Community, We have faced an issue with FEX connected devices during our recent ACI upgrade.- We did an ACI Fabric software upgrade upgrading first Odd and the Even switches, having FEXes attached to Leaf switches (Leaf 209 connecting to FEX101-A, ...
If you add a Standby APIC to the ACI infrastructure, you might get confused as I was. - The Standby APIC is shown in the System - Controllers topology, but serial number is shown instead of the name.- In the System / Controllers view, you will see on...
For test purposes, I have set up EP to Ext IP Atomic Counters. Surprisingly, the operational statistics show 50% packet drop, which absolutelly does not seem relevant.
- The ACI endpoint 10.50.6.100 is of type L3 and it is a single port (no port-chan...
No specific requirements have been specified. The design is for virtual desktops, essentially virtual machines, all within one subnet, who just need to reach to their default gateway which resides on the firewall. All security rules are handled by th...
I see two possible scenarios:
One Layer 2 Bridge Domain (BD) with two EPGS: isolated EPG-1 which is used for regular endpoint connectivity, EPG-2 which is used only for Firewall, contract between EPG1 and EPG2Two Layer 2 BDs, one L2 BD1/EPG1 with Int...
Hi M02@rt37,
Your answers seem to be very high level, but the scenario is a bit more complicated.
Since the BD/EPG is a Layer 2 type, the external firewall, which provides the default gateway and controls traffic in/out of the BD/EPG needs to be a p...
Yes, Jayesh,
I have tested this behaviour in our lab twice.
- Using this procedure, the Fault is cleared from the Fault log.
- Also, if a new Fault of the same type occures, it is logged once again (of course only in case you've deleted the relevan...
Finally, I have found a solution how to clear the F1394 fault.
- Go to System>Faults and find the F1394 fault in the table of faults and double click on the F1394 category.
- Choose one of the fault occurences, right-click on the fault and choose "Ig...
