jilahbg

HelloI have a C1800 router. I want to connect this to my LAN and 2 different ISPS (on fa0 and fa1 re...

Thanks tdrais! This sounds like what I am looking for. Great!Best regards Jimmy

HelloBGP peering is not an option. I am looking at a feature that will enable/disable an interface o...

HiI want to connect a Cisco-router (18xx?) to my LAN and to 2 different ISP:s. I want a feature that...

HelloAre there any security issues with running EAP-TLS and WEP (as in http://www.cisco.com/en/US/pa...

HelloBesides NAT and routes, You must also make sure that the traffic is allowed in the ACL applied ...

HelloTake a look in the doc about the "firewall transparent" command.This also explains some basics:...

Now I have added the max-associations command. Great!I dont have any cipher-configuration on the rad...

HiI want to secure the communications between 2 Br1310 acting as point2point bridges. That is, I wan...

HiI want to configure 2 1300 Bridges as a point2point-link between two buildings. I want the radio l...

HiNo, I want to lock the speed to 1000 and duplex to full on the GigabitETHERNET ports. Is that poss...

HiHow do I lock speed to 1000 and Duplex to full on a switch-interface in a Catalyst 3750? Default i...

HiIs it possible to do some kind of QoS in the pix to prioritize traffic going into Lan2Lan-tunnels ...

HiI did, but it´s the same thing.FastEthernet0/0 - Group 2 State is Active 9 state changes, last sta...