Hi
is there a trick on catalyst 9500 L3 Subinterfaces to capture packets via the "monitor capture" feature ?
I tried to capture traffic from Interface
!interface TenGigabitEthernet1/0/11.3261description tport / ETH-10577encapsulation dot1Q 3261ip v...
Hi
With our Guest SSID i use the implicit_deny_v6 ACL where is provided per default from the IOS-XE .
There was never a issue with IOS-XE17.3.XX with this ACL but something changed with 17.6 .
Since we use new C9800 Controllers with IOS-XE 17.6.4 ( ...
Hi
is there a Way to get a list from Rogue AP´s where sending with 160 MHz Channels ?
I could extract it from the CLI on a C9800 but i am looking for a much elegant solution.
Maybe someone knows how to get this information from Prime or DNAC.
Conten...
Hi
is there a knob in DNAC to change the direction in how DNA Center puts the Image onto the Router or Switch ?
If I interpret this error message correctly i would say : The router tries to establish a https or scp session to the DNAC to download th...
Hi
i deployed a Docker image on a Cat 9300 following this Guide
https://docs.thousandeyes.com/product-documentation/global-vantage-points/enterprise-agents/installing/cisco-devices/installing-enterprise-agents-on-cisco-switches-with-docker
but now...
Hi Flavio
yes , but i don´t use the vrf as a source, the Interface like i would interpret the doc like this.
monitor capture TESt interface vrf tport
that captures everyting from the vrf to the buffer.
And on the other hand i would expect that the c...
yes i already set the ipv6 ACL via CLI , i just found this issue accidentally , because i just wanted to change the VLAN for the SSID and where confused why the "update and apply to device" did not working and then i have seen that the GUI complains ...
tried already the Learn Device Config but it just complains most of the config about that this and that ist not supported with DNAC. ( WLC runs on 17.3 ) in the Model Config Editor are a couple of more options but still to less and they are named som...
Hi gone through a couple of Videos and Docs but no one showed me a solution to configure all the wireless feature on the DNA , like i have on the C9800 , and then assign them to a site . You can only configure a subset of features on the DNA for wir...
