I'm sure you've already looked, but have you run a show process cpu history on the devices to see if they're being taxed?

Looks like you need to addd the following:config t!interface vlan1 ip nat inside endEverything else looks ok. If that doesn't work, there are a few things you should check.1. From the CLI, enter the following from enable mode (MyRouter#): show ip ...

Send me a copy of the show run and the show flash. I'll throw in on my lab router and send it back.

Send me a copy of the show run and the show flash. I'll throw in on my lab router and send it back.

That's a tough one. You are limited in you troubleshooting ability with the CE500's which is why I personally prefer the 2960's which are close in price. Do you have any third party tools you can use to pull SNMP info?Here's a link I found:http://w...