I've unfortunately hit this bug with version 21.63 of the Staros software. The bug notice however says No release planned to fix this bugWhat does that mean (other than the obvious)?Surely that has to be fixed? it's a pretty big bug. When using LDP y...
I'm running a test lab in advance of getting it setup properly for the STAROS/VPC-SI software. I've got it all installed great but I've run into a problem and cannot get around it.I've setup a PDN context which will connect to the core network and it...
I've had a new ASR9001 installed for a week and I've just noticed (via Solarwinds) that it's showing lots of input drops on our uplink.
We don't have any issues with customers experiencing packet loss or slow speeds so it doesn't 'seem' to be ac...
I have a trunk coming into a CSR1000V. This trunk carries lots of VLANs and each VLAN has it's down routed subnet.
I want to be able to put a specific VLAN on this trunk into a customers VPLS. Is this possible?
I can move the interface as a whole ...
I'm setting up a test network using GNS3 for a VPLS network using a route reflector. This works great so far with other devices but I'm having a problem getting a CSR1000V router to participate as a PE device.
I have a CSR1000V which act's as the ro...
after tacking this for 2 days I've just figured out what is going wrong about 5 minutes after posting this but I think it's a bug rather than a config issue.it looks like it won't send LDP hello's if you set the router-id under the MPLS IP config to ...
Thanks again. I've google searched for the bug id's CSCul84303 and CSCux88695 but I can't see where it mentions it affecting individual interfaces? These also seem to be resolved by 6.4.1.
If it is a bug then great it means I can just schedule an upg...
Thanks. That bug seems to affect bundled interfaces however and this is just a standalone interface. I've seen other similar bugs effecting HSRP/VRRP but again this shouldn't be affected as we are not running those.
Could be another bug of course :/
It works :)
I didn't have to use the extra command-line switches however but that's even better from my perspective :)
Thanks Peter. Much appreciated :)
