p.hruby
Level 1
Level 1
Member since ‎05-23-2002
‎10-05-2023

User Statistics

  • 90 Posts
  • 3 Solutions
  • 53 Helpful votes Given
  • 19 Helpful votes Received
Recent Badges
CCP Member
1 Accepted Solution
10 Helpful Vote
50 Replies
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Is it possible to configure WAN edge on a router which is also configured as a MPLS PE towards internal (LAN) network? Several MPLS/VPNs are configured on this router (in separate VRFs). Networks from these VRFs must be accessible from remote locatio...
Is it possible to add a new spine into the existing fabric even if the spine is not conected to all leaves? I know this is not a valid design but I'd like to know if this works. Is there a document which describes ACI behaviour when some cables are n...
Could anyone point me to a documentation where the role of CSR routers used in cAPIC deployment is explained? cAPIC design guide or something similar.
I'd like to configure DMVPN hub behind static NAT. When Internet interface and Tunnel interface are in  the same VRF on the hub, everything works well. But when I put Internet interface into separate VRF, IPsec fails during phase 2. Hub configuratio...
I installed APIC-EM 1.4.0.1959. When I perform network discovery using CDP and seed device all devices are properly discovered but some links are missing. I've tried it several times but there were always some link missing. In one case there was disp...
Community Statistics
Member Since ‎05-23-2002 03:47 AM
Date Last Visited ‎10-05-2023 01:16 AM
Posts 90
Total Helpful Votes Received 19
Helpful Votes From
Helpful Votes Given To