Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
ROMAN TOMASEK
‎09-19-2018
Beginner
Recent Badges
Awards
Recent Badges
See all
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies
Stats
Member since ‎12-14-2001
355
Posts
9
Helpful
0
Solutions

conn reuse doesn't work in A5(1.0)

Created by in Application Networking
02-28-2012
02-28-2012
Hi Daniel,you are right. I configured L7 rule and for now it is working well. Thank you for your hel...

conn reuse doesn't work in A5(1.0)

Created by in Application Networking
02-24-2012
02-24-2012
Hi,I configured conn reuse and I tried to provide requests from diferent clients to the VIP address ...

Re: a DNAT is not working on ACE

Created by in Application Networking
02-14-2012
02-14-2012
Hi Christopher,so there is no possibility to provide destination NAT? For example in situation when ...

a DNAT is not working on ACE

Created by in Application Networking
02-14-2012
02-14-2012
Hi,I configured the DNAT on ACE. You can see this configuration below:access-list traffic line 8 ext...

what means "commandLets" in Compliance mgmt in LMS 4.1

Created by in Network Management
02-13-2012
02-13-2012
Hi,I provided a compliance check using an advanced template. This check shows me a lot of non-compli...

lms 4.0 - job scheduling and device group

Created by in Network Management
01-25-2012
01-25-2012
Hello,I have one question. I scheduled a periodic job (for example the compliance check job) on week...

LMS 3.2 doesn't terminated SSH sessions on ACE

Created by in Network Management
12-06-2011
12-06-2011
Hi,as I wrote before my problem was caused by Archive Poller. So my problem was solved by fetch inte...

LMS 3.2 doesn't terminated SSH sessions on ACE

Created by in Network Management
12-05-2011
12-05-2011
Hi Karoly,The problem was with the Archive Poller. I increased the fetch interval from 180s to 240s ...

wccp performance on ISR G2 routers

Created by in Application Networking
11-08-2011
11-08-2011
Hello Daniel,thank you very much for your information.Roman

wccp performance on ISR G2 routers

Created by in Application Networking
11-07-2011
11-07-2011
Hi all,do you have any information about the CPU load on the ISR G2 routers, when the wccp is config...

LMS 3.2 doesn't terminated SSH sessions on ACE

Created by in Network Management
08-29-2011
08-29-2011
Hi Gaganjeet,thank you very much for your reply. But I think, that this problem is with LMS, because...

LMS 3.2 doesn't terminated SSH sessions on ACE

Created by in Network Management
08-29-2011
08-29-2011
Hi all,the customer has a problem with LMS 3.2. This software doesn't terminate ssh sessions created...

NetConfig template for reload in LMS 4.0

Created by in Network Management
08-03-2011
08-03-2011
Hi all,I have one question about the reload template from Cisco. When I use this template I have to ...

native VLAN discrepancy is not reported in LMS 4.0

Created by in Network Management
08-02-2011
08-02-2011
Hi all,I have the following problem in LMS 4.0. I see a lot of CDP syslog messages about Native Vlan...

waas on SRE

Created by in Application Networking
07-21-2011
07-21-2011
thank you.Roman
Public Statistics
Date Registered ‎12-14-2001 08:00 AM
Date Last Visited ‎09-19-2018 06:18 AM
Total Messages Posted 355
Total Helpful Votes Received 9
Helpful Votes From
See all >