Hi,I think you're using the external directory command and will not work for local directory. See be...

Hi,what do you see when you input the url to internet explorer? what do you mean by "phone cannot lo...

Hi,the debug says you do not receive any signaling from the TELCO. could you try to make loopback te...

Hi,Sorry for the late reply. Can you post here the configuration for Dial-peer 1(incoming dialpeer) ...

hi Jomar,storage sites are restricted here in our company. Could you just upload here the txtfile of...

Then try creating an incoming voip dial-peer. then apply it on that. Also, can you check in CUCM wha...

yes it should be!! try configuring codec g711 under the outgoing dial-peer, or check your gateway co...

Hi,For me your config is just fine, please enable debug voice ccapi inout and capture the logs.enabl...

Hi,Can you share more information about your requirement. what are the devices involved, connection ...

Hi,Sorry as you've already mentioned that it didn't fixed the issue. Can you post here the whole pho...

Hi,where do you see the "cannot complete transfer" error? Is it working fine when a basic outbound c...

Hi,I encountered this problem that occurs only in video capable phones. Adding bearer-cap speech und...

Life changing!!!

Hi, you can use an h323 phone instead. try ephony . Sometimes, csim start helps depends on the situa...

Hi,If i may clarify, CUCM - mgcp - Router (isdn switchtype primary-dms100) - PSTN = not working?CUCM...