Our multicast service provider need IGMP join packet in order to send the multicast traffic. The service provider does not support PIM routing. We have a Cisco 4500X switch between the multicast service provider and the multicast receiver.
If I set o...
There are two multicast routers receiving same multicast stream from two inbound links. The routers have to select one stream and to forward it to an output interface.
There is a problem if the router sends back the incoming stream to the other inbou...
I cannot find in the data sheet of C881-V that the BRI interface could be used as ISDN network side function or not.Can I set these parameters?!interface BRIx isdn switch-type basic-net3 isdn protocol-emulate network isdn layer1-emulate network!Thank...
One of our customer has an UC520 system with SWP 7.0.2. They want to use new SPA303 phone but this version of sw does not support this type of phone.I read in the document of “UC 500 Software Packs” (https://supportforums.cisco.com/docs/DOC-9827) tha...
I could solve this problem using "ip igmp proxy-service".On the downlink interface I set these:!interface Vlan2 description Downlink ip pim passive ip igmp static-group <StreamGroupAddress> source <StreamSourceIP> ip igmp mroute-proxy Vlan3!On the up...
Hello Pieterh, Thanks your suggestion. I do not think that because R1 and R2 use "ip igmp static-group" on the outbound interface. The client does not need IGMP request in order to get the multicast traffic. Thanks, Laszlo
Hello Giuseppe, You are right. My system a little bit complicated than I wrote in my start message of this conversation. I use host routes as the static route and the Layer2 network has more IP network address: 1. Common IP network with the multicast...
Hi Ngkin,No.The static route via direct line is removed in 5 secs after the SRC becoming unreachable. It is good.The problem is the pruned multicast traffic enable again.I am going to try "ip pim join-prune-interval" on the interface to the other ro...
Hi all,There are Layer2 switches between SRC and (R1, R2), no MPLS. My initial figure was Layer3.I cannot use dynamic routing instead of static because there is not any router at the SRC.I do not think that PIM hello interval could help me because th...
