Peter_sgc_2

Peter_sgc_2 · 04-12-2013

Hello,How do I Setup and Configure a second auto-attendant on a UC560?I have been into the Unity-Exp...

Peter_sgc_2 · 04-03-2013

Dam, the SPA8000 is a lot more then the SPA112

Peter_sgc_2 · 04-03-2013

Aha, So it's the case of Configuring it via the CCA?It would need to be a Generic SIP Phone? Does th...

Peter_sgc_2 · 04-03-2013

So seeing as the ATA186 is end of life.Does the UC560 Suppot the "SPA112 2 Port Phone Adapter"http:/...

Peter_sgc_2 · 03-07-2013

No one at Distrubution sells the ATA 186

Peter_sgc_2 · 03-07-2013

Hello,Is the Cisco ATA 187 supported on the UC560 ?

Peter_sgc_2 · 01-07-2013

Hmmm Ok,Starting to make Sense.So If you dont use "Diversity" mode the Left antenna becomes useless?...

Peter_sgc_2 · 01-07-2013

Thanks for the information George, I will take a look as see what I can work out.I haven't done a pr...

Peter_sgc_2 · 12-11-2012

Reading through lots and lots of post about this I still can't figure out if there has been a "Simpl...

Peter_sgc_2 · 11-27-2012

Yup, 9 Months ago I relasied this.But thanks.@Juna Thats just a service type for passing BGP to some...

Peter_sgc_2 · 10-18-2012

Hello,Does anyone have a guide on how to setup 802.1x on the Cisco 500 Series Switches.I have done t...

Peter_sgc_2 · 10-03-2012

Bump!

Peter_sgc_2 · 09-24-2012

We are using F/W 2.1.71I'm not sure if this is a Firmware Issue, It could be the speed these HTTP re...

Peter_sgc_2 · 09-24-2012

Hi Thomas.I have disabled IPS on the SA, but we still have the same issue here with HTTP Traffic.Jim...

Peter_sgc_2 · 09-21-2012

Yes we are using IPSWhen I get back to the office I will try and disable this.Is this a known issue?...

Date Registered	‎11-16-2009 05:40 AM
Date Last Visited	‎08-18-2017 04:01 AM
Total Messages Posted	105
Total Helpful Votes Received	15

2nd Auto-Attendant