Hi,I am trying to register a CUBE to an itsp without success.I tried several configurations and I've read many community posts about this argument. I have a Cisco router with IOS-XE Version 16.09.05.I've also activated some debugs.I notice this messa...
Hi,
I've Cisco ISE 2.2.0.470 patch 1.
Every time that a user tries to access the network via MAB Authentication, authentication fails.
Failure reason is "22017 Selected Identity Source is DenyAccess".
The resolution is Select a different identity sou...
Hi,
I've a Cisco 3850 with WLC functionalities enabled.
I notice that there is a trunk between the switch and a capwap interface associated to an access-point.
I also notice that all vlans configured on the switch are allowed on that trunk.
How is it...
Hi,
I have two ASA5508 with firepower services configured in failover mode.
I would activate VPN Remote Site services and I would to use Cisco Anyconnect tool for VPN with SSL protocol.
Actually I haven't licenses to use Anyconnect with SSL protocol....
Hi,
I've Cisco ISE 2.1 with patch 1.
I have applied an Authorization Policy that send an Access_Reject to NAD when a certain endpoint connects to the network.
I notice that ISE correctly begins to log the authorization failures of that endpoint.
Aft...
Hi,finally it works.As also you have suggested, it was very important a feedback that the provider has given to me some days ago about some transformations regarding FROM and TO sections of SIP messages.In fact, as we also have noticed, the standard ...
Hi,the strange thing is that the messages that my CUBE sends to ITSP have the IP address of provider in FROM section.This is the error that provider reports to me and the strange thing that I also notice and it is reported in the previous logs. For e...
Hi,thanks for this suggestion.I configure the credentials as you have written.It doesn't register but maybe the Register messages change: now I receive a USER UNKNOWN response.Here the new register messages. Mar 10 19:40:34.515: //3826/000000000000/S...
Hi,thanks for your reply.I have written some days ago to the ITSP about URI in the form of Register message but I am still waiting for the response.These are my configurations and at last some O2 parameters. *** VOICE SERVICE VOIP ***voice service v...
Hi,I activate the debus as you wrote me.Here the logs.You can notice that there are some messages between the two CUCM servers (IP is masked with the words "IP_CUCM1" and "IP_CUCM2") and my router (IP is masked with the word "IP_MYCUBE"): these SIP s...
