Hi all
I have an issue with deploying images to Catalyst 9500-24Y4C using SWIM.
Some background: I have added two C9500-24Y4C manually configured into DNAC using device discovery. This went fine and I was able to upgrade them using SWIM to IOS-XE ver...
HiI'm trying to connect a full-IOS Cisco 1142 access point as WGB to our WLAN infrastructure.I have these settings configured on our WLC:There is a Win2k8 R2 NPS (Network Policy Server) RADIUS server in the background for handling the authentications...
HiI recently made a fresh install of LMS 4.1 and added all of our devices (about 400 devices). After configuring all jobs and services everything ran fine.After a few days a guy from the server team called me and told me that the CPU-usage increased ...
HiSince some months I'm running ACS 5.2 appliance without any problems. Today I found a very strange problem:When I want to change the password from a local user there's a popup message:"This System Failure occurred: {0}. Your changes have not been s...
Hi I like to migrate from ACS 4.1 to ACS 5.2. I've already configured TACACS+ authentication but now I stuck at configuring RADIUS authentication for WebVPN remote access. Please look at the diagram below: I want to configure ACS to use OTP Token Se...
SR has finally been closed.
It seems like if SWIM is starting file transfer over NETCONF, the switch uses the DNAC-facing-interface which is part of the underlay. That means it does not consider "ip http client source-interface Loopback0". Since that...
Hi Will
Finally an update. I did a lot of troubleshooting, packet captures and RCA together with TAC. TAC was not able to finde the cause and assigned a bug id to this problem:
CSCwe17731
I think I'll have some more TAC sessions
I got a similar error like on your screenshot:
But it's not very informative.
I went into Activities - Audit Logs and found a proof that DNAC want's to initiate file transfer using NETCONF:
After about 8 minutes I'll get the error "HTTPS.Image copy...
Hi Will
Thank you for your reply and the tests you've made.
Because of your inputs I've run the same tests you did. My results confirmed your results:
When NETCONF on the mentioned Cat9500 is disabled (i.e. NETCONF port is removed from device setting...
