About R0g22

R0g22 · 02-05-2019

There is a timeout happening -005208: Feb 5 2019 19:27:51.034 UTC: %VOICE_IEC-3-GW: SIP: Internal Error (ACK wait timeout): IEC=1.1.129.7.66.0 on callID 1180 GUID=EE74742F28B211E98551D21BBC9A1796005209: Feb 5 2019 19:27:51.035 UTC: //1180/EE74742F8...

R0g22 · 02-05-2019

AFAIK the requirement is still the same.If you are splitting the CUBE's across DC's, you cannot use HSRP. You could have an ACTIVE/ACTIVE CUBE deployment where the CUCM will be responsible for failover etc.

R0g22 · 02-05-2019

Not sure why would you buy a BE6k for 60 users only. If that is the case though, look into a CME/CUE bundle running on a ISR-4k box. If you have a virtual environment, you can deploy a vCUE for the voicemail bit.Also, you could look into BE4k for a c...

R0g22 · 12-20-2018

Could not figure out what the issue is but you are missing "type" command from the ephone config. If your issue is that the dn does not appear on the ephone, that should fix it. Add the command, recreate config file and reset the phone.

R0g22 · 12-20-2018

Do you have SRST or CME-as-SRST configured ? With SRST, phones do not get config file from the SRST router.

Member Since	‎08-23-2014 05:44 AM
Date Last Visited	‎04-03-2024 12:05 AM
Posts	2,392
Total Helpful Votes Received	2166

User Statistics

User Activity

Re: Static SIP Service

Re: CUBE-ENT and HA when using two sites

Re: Low-cost, long-life, simple VOIP phone controller?

Re: Allocating DID's in CME

Re: SIP Phone registration with CME with Logged out extension