About hostasaurus

hostasaurus · 02-02-2024

Anyone seen this error before? RP/0/RP0/CPU0:Feb 2 22:49:49.944 UTC: locald_DLRSC[302]: %SECURITY-PKI-6-ERR_3_PARAM : Crypto engine decrypt failed : 'Crypto Engine' detected the 'warning' condition 'RSA public key decryption failed' 1116083200 Th...

hostasaurus · 11-16-2023

Hi all, IOS-XR 7.5.2 on NCS5501. Was curious if anyone knows a command to allow a new administrative distance to apply without a hard BGP session reset? I'm trying to prioritize OSPF on internet-facing edge routers that have numerous eBGP peering s...

hostasaurus · 05-01-2023

Hi all, I'm moving from a 3504 WAC to an EWC on a 9130AX and still trying to fully understand the conversion from WAC config to the various tags and profiles in EWC. Is there a layman's guide somewhere which walks one through the major WAC setting e...

hostasaurus · 08-31-2022

I'm trying to take an NCS5501-SE from 663 to 7.x. First ran into the issue that ncs5500-eigrp is no longer present, at least not in the early 7.x releases which I'm required to go to as an intermediate. Fortunately I don't use EIGRP. I deactivate ...

hostasaurus · 02-04-2021

Hi all, could not find anything in the release notes, or online. Recently updated a 5501SE from 6.2.3 to 6.6.3. It has a bunch of eBGP peers, single hop, all had ttl-security set on all v4 and v6 sessions. The v4 sessions came up, the v6 did not. ...

hostasaurus · 11-16-2023

Huh? That is the entire purpose of this thread. I outlined that soft reconfig is not applying admin distance changes, and is there a workaround. David reproduced and determined that a weight change on a per-peer basis causes a RIB replacement, all...

hostasaurus · 11-16-2023

Thanks David, I tried that with one peer and it worked for me as well. It will take some labor time to tinker with each peer and soft reset, but now I can avoid the interruption since this device is at an IXP with ~20 sessions, where backup would be...

hostasaurus · 11-16-2023

Yep looks good there: Neighbor capabilities:Route refresh: advertised (old + new) and received (old + new)Graceful Restart (GR Awareness): received4-byte AS: advertised and receivedAddress family IPv4 Unicast: advertised and received

hostasaurus · 05-01-2023

Thanks. I'm not sure how to get from WLC to attempted config for the wireless config analyzer to work. It did output some very useful suggestions for the current WLC that it didn't produce itself in its own best practices analysis, so that's very h...

hostasaurus · 09-26-2022

Yeah that was the path I took; just make sure all the "show hw-module fpd" outputs are clean before proceeding. Also, if you're used to just uploading the tar file, 7.5.2 grew too large to do that, so you'll have to extract it yourself and upload th...

Member Since	‎09-25-2014 06:26 PM
Date Last Visited	‎11-29-2023 09:58 PM
Posts	71
Total Helpful Votes Received	26

User Statistics

User Activity

IOS XR ssh decryption failure

Any way to apply new BGP admin distance with only soft reconfig (XR)?

Terminology map from WAC to EWC? AP groups in particular

How to remove an inactive but committed package?

Any known issues/changes with ttl-security between 6.2.3 and 6.6.3 (NCS5501se)?

Re: Any way to apply new BGP admin distance with only soft reconfig (X

Re: Any way to apply new BGP admin distance with only soft reconfig (X

Re: Any way to apply new BGP admin distance with only soft reconfig (X

Re: Terminology map from WAC to EWC? AP groups in particular

Re: after NCS 5501-SE upgrade from 7.0.1 to 7.0.2 - UPGD FAIL status