Hi all, I'm trying to setup a IOS(-XE) based ZFB-firewall to filter and block traffic between 2 LAN-segments. I have a list of ports which I want to allow but I find it hard to find an example to match a port in a class map if the port does not match...
Hi all, I was going through the Cisco access point portfolio looking for the most suitable access point in a cold (-26C) environment. The building is a warehouse with frozen stuff, about 15m high (45') There a are a few options:1. Indoor AP in a spec...
Hello all, On of our customers has a BE6K based on an older C220. They ordered a new C220 and they want to migrate/upgrade to 12.x. This job can be done with PCD and if I look at the Cisco Live presentation slides the current cluster will be down whi...
Hello all, today I encountered a strange issue which I haven't seen before. Inbound calls coming from the PSTN (SIP trunk via a CUBE) lose the calling party number. The setup Provider - CUBE - CUCM (11.5su2 or 5, have to check) The CUBE traces show t...
Hello all,
Setup : 3504 WLC HA-pair, 8.5.140 and 2802i Access points
This is a new setup and after configuring the WLC and adding the APs, a handful APs did not join due to cabling problems. After these problems were resolved the APs tried to joi...
These are warehouse size freezers so the APs must be installed inside. We have one customer who has a DIY-solution: they bought 2702e APs and put them in a IP65 box. Added some temperature sensors and measured the temperature. They discovered if they...
It's pretty hard to get any signal out of a freezer so I guess radar will not get in. You're right about that.Just looked at the datasheet and when using POE+ instead of UPOE, the AP loses one spatial stream (2x2 vs 3x3). Don't see that as an isue be...
Thank you all for the great replies. I get a feeling what to expect. Most migrations I did up till now where 'start over' migrations (starting all over with a new configuration). I guess I will use the DRS option because that does not touch the produ...
Hello Mohammed, DNA would have told me everything is ok because the CUCM part was configured right, the CUBE was stripping the caller ID. With kind regards, Marcel Tempelman.
Problem solved. Looking back it was quite obvious but I'd like to share it anyway. I was looking through the SDL trace and I found this:36192083.017 |12:25:51.710 |AppInfo |DbMobility: getMatchedRemDest starts: cnumber = @customername.ispname.nl36192...