HiI have a costumor that has set up two 8510 in AP SSO mode using version 7.4 between two data centres. The redundancy port is connected using a flat vlan spanning the two centers. I know that this is not recommended, but this is how it done.Now read...

I have an installation with both AIR-CT5508 and AIR-CT8510 controllers and 3602 access points. We have a couple og log messages that we are unable to find out what means. The installations being done together with a costumer that is very keen on vali...

I have searched and asked round for this the last weeks. Can't find the answer.When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a ...

After a crash of a MSE last week we have 8 critical alarms i Cisco WCS. One for each WiSM IPNMSP Connection Status: INACTIVE, Controller IP: <IP>The alarm is created the same time as the MSE crash.The "NMSP Connection Status" show ACTIVE and the trac...