I have a weird problem I have seen on more than one occasion which I'm sure has a simple solution but I'm at a loss as to what that could be. The Outside interface always shows twice the traffic throughput of the Inside interface. I've attached a ...
I'm trying to configure a vCube with a SIP provider IXICA and I have inbound calls working but outbound calls drop after 3 seconds whether answered or not. It appears as though I'm sending and ACK and right after that a SIP "BYE" message but I can'...
I have an interesting problem. We have a branch office which connects to our main site via a site to site vpn tunnel with ASAs running 9.x code on either end.Calling from the branch IP phones to main site phones works well however any calls from the...
I am in the middle of migrating 3502i's from WISM to 5760 wireless controllers and have come across a troubling problem. I have a few different SSID's advertised and 7925's connect and roam fine. Windows devices connect fine to all SSIDs however ap...
So I've been working off and on building a new phone system for our remote sites and I've run into a mental block. Each of the 4 remote sites which are configured in a full mesh VPN will get a 2921 router configured as an H323 gateway running CME as...
I had the same issue after upgrading to 8.0.150.0 today. It looks like the username is "admin" and the password is whatever the "root" password is for PRIME to MSE communication.
Well that did it. Everything appears to be working. I've flipped the CUCM trunk back to TCP. I'm still a bit confused as to why it was pulling the wrong dial-peer but I think I understand the logic. Which leg of the call did this dialpeer fix? ...
OK so I've done another debug which is attached. For simplicity sake I've changed the CUCM > Cube SIP trunk to UDP and defined UDP on all voip dial-peers. On an outbound call I now get one way audio but it still disconnects after 3 seconds.
10.1...
Did you ever find a solution to this problem? I have 1142 WGBs that are exhibiting the same behavior. A reboot of the WGB is the only way to bring the client devices back to life.
TAC has been working on it for some time now without any success.
