About Daniel Boling

Daniel Boling · 06-13-2013

I have this configuration in many routers:ip local pool COMPANYVPN_POOL 172.30.255.1 172.30.255.254crypto ipsec transform-set COMPANYVPN_SET esp-3des esp-sha-hmaccrypto isakmp client configuration group COMPANYVPNkey <company_password>dns <company_dn...

Daniel Boling · 03-24-2013

Relevant Topology:(Corporate LAN: 10.10.0.0/21) > (Catalyst 3560 L3 Switch: # ip routing) > (10.10.255.253/30) > (Cisco 1921: edge router) > ISPOne-to-One NAT statement in edge router:# ip nat inside source static <inside local ip> <inside global ip...

Daniel Boling · 03-18-2013

I ordered 2 WS-C2960S-48TD-L switchesI also ordered the Axiom equivelent to the SFP-10G-SR (SFP-10G-SR-AX) per the 10-Gigabit Ethernet Transceiver Modules Compatibility Matrix (http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/co...

Daniel Boling · 01-30-2013

Switch A is: WS-C2960-48TC-SSwitch B is: SG 300-10MPNeither switch supports a similiar transceiver module. We are looking at transceiver GLC-SX-MM for Switch A, and MGBSX1 for Switch BAll the Layer-1 information (SX / wavelength, Multi Mode, etc.) I...

Daniel Boling · 01-19-2013

Relevent topology:-------------------Area 0--------------------------------------------Area 1----------------------------------------- Router 1 > transit network > Router 2 (ABR) > point-to-point link > Router 3 > stub network ...

Daniel Boling · 12-09-2013

Is your default gateway configured on the DVR?

Daniel Boling · 12-09-2013

Here is a really good discussion I remember reading a while back: https://learningnetwork.cisco.com/thread/37638

Daniel Boling · 12-09-2013

Bryan,Wilson is asking you to run the commands show interfaces and show interfaces status err-disabled from the CLI and post the output. You might also make sure the 3COM switch does not have any conflicting VLAN configuration.

Daniel Boling · 10-01-2013

Eric,You do have to have ip nat inside configured in your subinterfaces.Let's narow this down a bit. Have (at least) the following configured:interface GigabitEthernet0/0Ip address dhcp ip nat outsideno shutdowninterface GigabitEthernet0/1no ip addr...

Daniel Boling · 09-29-2013

Andre,Use "ip address negotiated" instead of "ip address dhcp hostname MYROUTER" under the Dialer0 interface

Member Since	‎08-03-2011 12:56 PM
Date Last Visited	‎02-20-2019 02:06 AM
Posts	33
Total Helpful Votes Received	15

User Statistics

User Activity

Different local ident values using the same VPN profile

One-to-One NAT interfering with Site-to-Site VPN

Cisco Catalyst WS-C2960S-48TD-L + SFP-10G-SR-AX issues

Difference between trasnceivers

OSPF not creating Type 3 LSA for Point-to-Point link

Cisco 1921 port forward not working

OSPF mtu mismatch question

Cisco 881W switch connection issue

Re: Issue routing traffic through my 2851 router

877 no connection to Internet. CD and PPP lights are steady on