Dear Experts,I am facing a problem with HSRP MAC Flap. I have two routers in HSRP working perfectly. When I am trying to add the third router to the same HSRP group I am facing HSRP MAC Flap and the other two routers also getting disturbed.I have att...
Dear Experts,
We have to create Admin Accounts for Support Engineers, They should have access to Only selected Pages and Selected Features:
1. Device Tab - Phone Administration - Add / Remove / Reset Phones
2. Call Routing - Client Matter Code - ...
Hi All, I have some confusion about the renewal of Smartnet Contract for IP Telephony.
What I understand is:
1. If I take support for UCS servers by providing Chassis number, I will get support for Hardware
2. If I take ISV1 support, I will get sup...
Dears,
I have a requirment to have access controll list in WLAN controller. we want to give limited access to Level-1 team.
the access should be limited to adding and deleting MAC address authentication.
I tried searching but didn't find any thing...
Dears, I am not able to ping the intreface when I applied the NAT command to the interface. When we remove the NAT command we are able to reach the interface.
There is no change in Configuration and this happend all of a sudden.
Below is NAT and In...
I used below steps and the requirement is achieved:
1. Create "Access Control Group"
2. Add Users to the Group
3. Create and Role and add the Role to Access Control Group you created in 1st step
4. Add the Read and Update values in the Role:
- CMC ...
Dear Rajan, If I take smartnet support for UCS Chassis and ISV1, will it be enough to log a call for any issues related to services installed in UCS server. Kindly confirm.
Please share if there is any cisco URL related to this topic.
The issue was because of the ACL entry 'any any' in ACL 101. The Interface IP was getting natted because of this ACL entry.
I removed the ACL entry and the things started working fine.
Dears, I suspect the issue is because of the ACL Entry 'access-list 101 permit ip any any'
I am arranging the onsite engineer to visit the site, I will remove this entry and then will update the discussion. There is no issue with any other configura...
