About Kaushik Ray

Kaushik Ray · 11-14-2016

Hello I had a switch which had the configuration as ntp server 1.1.1.1 I have to restrict this so did the following -- no ntp server 1.1.1.1 switch(config)#access-list 20 remark NTP-ACLswitch(config)#access-list 20 permit 1.1.1.1switch(config)...

Kaushik Ray · 11-05-2015

Hello All I am tryinging to find where a port (7800) is being blocked withing a section of the network which does not have any firewalls. Is there any way i can try to find where the port is getting blocked in the network section? thanks

Kaushik Ray · 10-27-2015

Hello All I am seeing a issue and would be grateful to have any assistance regarding this. My setup is as follows: Router --> Core SW --> LAN Switch I am trying to gain access to the SH using AUX port -- Router config is interface GigabitEthernet0/0...

Kaushik Ray · 09-29-2015

Hello all I am trying to restrict VPN access from a couple of subnets on a Cisco Router. The following is the config I have put in but it still allows VPN to establish. Cisco AnyConnect is being used as a VPN ClientRTR# sh run | section ip access-lis...

Kaushik Ray · 09-15-2015

Hello I am wanting to add a splash page on one of the WLANs on the WLC (2504, 7.4.100.60) so that any time when users are signing on to the WiFi account it automatically redirect to this web page. How best is the way to go about it?

Kaushik Ray · 10-27-2015

Thanks Reza for your reply. But if we consider a workstation connected to the port it should always be an access port right? even though the router is configured as encapsulation?

Kaushik Ray · 09-18-2015

Thanks Josh Yes I am just looking to redirect the web login page... HOw do i go about that? Thanks

Kaushik Ray · 08-14-2015

Anyone can advise on this please? Thanks in advance

Kaushik Ray · 08-13-2015

Thanks Ali

Kaushik Ray · 08-13-2015

Thanks Dan for your views on this.

Member Since	‎03-16-2012 08:00 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	322
Total Helpful Votes Received	5

User Statistics

User Activity

NTP Issues

Check for Blocked Port

MAC address table not showing up

Using ACL to restrict VPN access from a Subnet

Landing/Splash Page on WLC

Thanks Reza for your reply.

Thanks Josh Yes I am just

Anyone can advise on this

Thanks Ali

Thanks Dan for your views on