Hello
I had a switch which had the configuration as
ntp server 1.1.1.1
I have to restrict this so did the following --
no ntp server 1.1.1.1
switch(config)#access-list 20 remark NTP-ACLswitch(config)#access-list 20 permit 1.1.1.1switch(config)...
Hello All
I am tryinging to find where a port (7800) is being blocked withing a section of the network which does not have any firewalls.
Is there any way i can try to find where the port is getting blocked in the network section?
thanks
Hello All I am seeing a issue and would be grateful to have any assistance regarding this. My setup is as follows: Router --> Core SW --> LAN Switch I am trying to gain access to the SH using AUX port -- Router config is interface GigabitEthernet0/0...
Hello all I am trying to restrict VPN access from a couple of subnets on a Cisco Router. The following is the config I have put in but it still allows VPN to establish. Cisco AnyConnect is being used as a VPN ClientRTR# sh run | section ip access-lis...
Hello I am wanting to add a splash page on one of the WLANs on the WLC (2504, 7.4.100.60) so that any time when users are signing on to the WiFi account it automatically redirect to this web page. How best is the way to go about it?
Thanks Reza for your reply. But if we consider a workstation connected to the port it should always be an access port right? even though the router is configured as encapsulation?