hi! if I've a few questions about vlan1 switch1) can I shutdown the vlan 1 in a flat network, and at the same time able to manage the switch remotely? Otherwise, how do I enable remote management?2) will there be any downtime to the user if I shutdow...
hi! In our network, we've 2x L3 4506 switches running HSRP and with a couple of edge switches connected to these 2 core switches.
I'm trying to turn on Port spanning for a few VLANs and trunk/access ports in one of the L3 4506 to be monitored in a de...
hi! when we subscibe to the internet with static public IP address (WAN(CE/PE) & LAN pool), do we need to tell the telco to set the internal LAN interface IP address in the Telco router/marc?Eg. if i'm assigned a public LAN ip range of 2.2.2.0/29.I'm...
hi! I noticed that there is an issue with my call forwarding in call mgr. Whenever I do a call forwarding the external number caller id will be appended to our internal prefix. eg. internal extension is in this format 6110xxxx, when the external user...
hi! i've a few sites with setup as option 1 in the diagram attached, whereby i've a WAN vlan with FW, Telco MPLS router and an ASA(backup link) connected to this WAN VLAN. The FW and ASA will have a route back to the internal netowk of 10.1.1.0/24 an...
hi! For the last question. Do you mean I do not have to shutdown the vlan1 on the router and create another vlan eg. vlan20 to match with the newly created vlan20 I have at the L2 switch end?with the newly created vlan 20 in the L2 switch. Is there a...
hi! If i understand you correctly. I would have something as followTelco router-----/30--------My FW------NAT /29-----public facing equipmentIs that correct?How about? This is my understanding on how it shd be setup.PE/----/30-----CE telco router---...
hi! I was given a PE/CE IP adress which is the /30 network + a range of pulbic lan ip address of /29, which i can use it for my fw, dmz device and etc.
