About Anderson Ribeiro

Anderson Ribeiro · 12-19-2016

Hi guys! I am currently using the Cisco Client VPN (In my Windows - Home Office), configured on a router Cisco 2811 and IOS c2800nm-advipservicesk9-mz.124-3a.bin. However, when there is a drop in my internet, on the client side, when I return my t...

Anderson Ribeiro · 06-17-2016

Hi guys! I need to create a VPN between my Cisco Router with IOS "c1841-advipservicesk9-mz.124-25a.bin" and my customer (I do not know what the equipment used by him). In this VPN have two PEER's from my customer that I configured. Follow a part th...

Anderson Ribeiro · 12-07-2015

Hi! I need renew my certificate and to do this I need generate a new CSR. My doubt is if I generate a new CSR my current certificate will lost or not. The command that I'll use to generate a new CSR is: # crypto ca enroll XXX Thank you.

Anderson Ribeiro · 11-25-2015

Hi guys! I have a doubt here, I have a Cisco FWSM and I would like to active the parameter describe bellow: "Enable traffic between two or more hosts connected to the same interface" The motive to enable this is because I have many static rules w...

Anderson Ribeiro · 03-19-2015

Hi guys! I have a Cisco 6509 with a FWSM. In FWSM I have a 2 contexts. Today I tried put a nat line and I received the message: fwsm-virtual/fw01spo(config)# nat (NUVEM-NEG) 47 access-list NUVEMERROR: Unable to add Policy Rulesfwsm-virtual/fw01spo(co...

Anderson Ribeiro · 08-11-2016

I have the exactly same problem. I have many cases like: static (inside,dmz) 10.10.10.0 10.10.10.0 netmask 255.255.255.0 And arrived the limit: statics 2048 2048 2048 61 System If I enable "xlate-bypass", can I delete this lines without problem? ...

Anderson Ribeiro · 12-09-2015

Hi Randy! Thank you for help!

Anderson Ribeiro · 11-26-2015

FWSM Firewall Version 4.1(11) The problem is that I would like not use static rules when the rule is to same IP. I want to use only access-list in this case. I saw in the documentation about "Static Identity NAT" For example, I have the IP 10.10...

Anderson Ribeiro · 11-25-2015

Ok, sorry. I understood that I said. How you would to do use only the acl in this case? Thank you.

Anderson Ribeiro · 11-25-2015

For example, if I need create the rule where the IP 10.10.10.10 (Interface ADV-X) connect to 20.20.20.20 (Interface ADV-Y), so I need do this: access-list ADV-X extended permit ip any host 10.10.10.10 host 20.20.20.20 static (ADV-Y,ADV-X) 20.20.20.20...

Member Since	‎05-23-2012 04:24 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	40
Total Helpful Votes Received	5

User Statistics

User Activity

Problem - VPN Cisco Client - Timeout

PEER ID / LOCAL ID - VPN ROUTER CISCO

Renew Certificate - Cisco VPN (Router)

CISCO FWSM - Enable traffic between two or more hosts connected to the same interface

Problem: ERROR: Unable to add Policy Rules

I have the exactly same

Hi Randy!

FWSM Firewall Version 4.1(11)

Ok, sorry. I understood that

For example, if I need create