About avilt

avilt · 05-11-2021

I have a requirement to implement routing among 3 locations as shown in the following diagram. Location A.B & C are in a unique subnet in default vlan1. I cannot make any changes on these networks (A, B & C) because it's not under my control. Now I a...

avilt · 04-04-2021

I have setup 9300 switches, the IP is defined only on MGMT interface. But the time sync fails, I have other devices which are getting time from the same NTP server. Any advise. MGMT01#show running-config | include ntpntp source GigabitEthernet0/0ntp ...

avilt · 04-03-2021

I have defined VTY 0 15 timeout, my SSH session is on MGMT (out of band) interface and vty timeout is not working. How do I enable it for MGMT as well?

avilt · 03-26-2021

On a Cisco switch, if I define MGMT out of band IP address, how do I define the default gateway for it which should remain out of band? Example: I have a 9300 switch with two vlans 192.168.1.x & 192.168.2.x with vlan IP interfaces and also a default ...

avilt · 03-26-2021

I have configured 9300 switch with management on MGMT port. No IP defined on vlan or physical interfaces.I have configured snmp V3 and I am unable to monitor the switch using my NMS software. Is there any specific setting need to be defined to monito...

avilt · 05-12-2021

Default Gateway is not yet configured, it is to be defined after setting up L3 sswitch.

avilt · 05-11-2021

Right now there is no communication among these 3 locations and are on L2 switch. Routing protocol is not supported.Also the FO link from L3 to other switch is a single FO link.

avilt · 04-04-2021

thank you. it works now

avilt · 04-04-2021

show runMGMT01#show running-config | in ntp10 permit udp host 172.16.50.72 host 172.16.50.100 eq ntp log20 permit udp host 172.16.50.100 eq ntp host 172.16.50.72ntp server 172.16.50.100 prefer source GigabitEthernet0/0 I see the following logs *Apr ...

avilt · 04-03-2021

I have the following commands but no ssh session never gets disconnected. SW01#show running-config | include sship ssh maxstartups 10ip ssh time-out 30ip ssh authentication-retries 5ip ssh logging eventsip ssh version 2 -----Also defined following c...

Member Since	‎04-13-2004 03:30 AM
Date Last Visited	‎05-12-2021 12:53 AM
Posts	538
Total Helpful Votes Received	40

User Statistics

User Activity

Switching Advice

Clock is unsynchronized, stratum 16, no reference clock

VTY Session Timeout

Cisco Switch MGMT Default Gateway

9300 SNMP Management

Re: Switching Advice

Re: Switching Advice

Re: Clock is unsynchronized, stratum 16, no reference clock

Re: Clock is unsynchronized, stratum 16, no reference clock

Re: VTY Session Timeout