Jack Germanos

Try the codec G711 and play around with SIP setting T38 and pass through you might get luckySent fro...

I had the same problem I run the following configuration1 x UC320 (using FXS port of system)2 x SPA8...

How many DID numbers can you map for outbound Caller ID?I ran into a problem with a 14 user system I...

Switch firmware UG fixed it for me, what type of switch are you using?Sent from Cisco Technical Supp...

Check the switch firmware upgrade it that helped meSent from Cisco Technical Support iPhone App

I have a similar set up and experiencing similar issue the sidecars are suspect but not sure.Sent fr...

This thread is gold! VLAN 1 lolSent from Cisco Technical Support iPhone App

Hi there I too have a customer with similar or exact issue delay 2-3 seconds on internal calls has t...

Hi there I have hit the same speed hump as per original discussion, my original issue as stated belo...

Yes I found out the hard way that the UC320 and SPA500DS are not compatible I have also read about t...

Hi There I am encountering a similar issue with a single site using the following:1 x Cisco SRP 527W...

Well both units have been RMA'ed, replaced them an uploaded saved Config and the FXS port works perf...

Hi WenjinI have finally able to run the FXS top FXO loop back test for my client the results come ba...