About Haris P

Haris P · 02-10-2014

I'm trying to configure PPPoE between two routers ...PPPoE is establishing , but unable to pingServerusername R4 password 0 CISCObba-group pppoe CISCO virtual-template 1interface Virtual-Template1 ip address 19.19.34.3 255.255.255.0 peer default ip ...

Haris P · 09-10-2013

Dear All ,Is there is any additional RJ45 Gigethernet Option for 7200VxR routers . I search on cisco and Unfortunately i didn't find any Gig ethernet PA for 7200VxR other than PA-GE . PA-GE only supports fiber but I need ethernet RegardsHaris P

Haris P · 07-25-2013

Dear All ,I created a L2tunnel between two of my PE's and it is working fine . The Vlans are configured in dot1Q sub interfaces and then it is connected to trunk port of the switch . From the switch i can ping the other side PC ,so the l2 tunnel is ...

Haris P · 07-03-2013

Dears , I have 2 6500 switches both with same image s72033-adventerprisek9_wan-mz.122-33.SXH7.bin but hardware is different cisco WS-C6509 (R7000) with WS-SUP720-3B and cisco WS-C6509-NEB-A (R7000) Is it possible for me to configure VSS on these boxe...

Haris P · 04-27-2013

Dears ,Can I upgrade ASA from "disk0:/asa708-k8.bin" & asdm-508.bin directly to asa825-33-k8 and asdm-712 ? What is the proceedure if i go from 7 to 8 ? For me what will be the suggested upgrade from asa708-k8.bin & asdm-508.bin ??I will rate ...

Haris P · 04-03-2018

can you check attached file

Haris P · 07-31-2013

No replySent from Cisco Technical Support iPhone App

Haris P · 02-25-2013

The Original Post is in AAA , Identity and NAC group ,but normally we get very low response from that section ... i want to delete it , but there is no delete button ..Please tell me what i can do in this case https://supportforums.cisco.com/message/...

Haris P · 12-05-2012

The below is my debugs .... I'm not seeing any STP passing through the switches thru the l2 xconnect , both side switches as root for the VLANs 102....running me crazy !!Dec 5 18:27:25.202: AToM MGR [10.101.0.1, 102]: Event ldp down, state changed f...

Haris P · 12-04-2012

In both ends my hosts are connected in acces ports and the PE is connected to trunk port of the switch . it is as shown below In fact i tried configuring an IP in the same range of the PC on my router dot1Q interface and i was able to ping the host ...

Member Since	‎10-30-2006 11:48 AM
Date Last Visited	‎10-22-2021 12:04 AM
Posts	325
Total Helpful Votes Received	49

User Statistics

User Activity

PPPoE Unable to ping

Additional GigEthernet Rj45(TX) Option for 7200VxR ?

Tunneling trunk through L2MPLS VPN

VSS on 6500 help needed

ASA 5510 upgrade from 7 to 8

Re: Reroute the traffic during the congestion

Re: Tunneling trunk through L2MPLS VPN

The ADSL Modem CISCO867-K9 not connecting with default mtu confi

not able to ping in l2 xconnect

not able to ping in l2 xconnect