Thanks.are you talking about the ACL access-list inside_mpc ?If so i havent assigned it to an interf...

Many thanksWhat I want to achieve is thisBT line ----------------ADSL modem (bridge mode)-----------...

Hi,Can anyone tell me what the new command is for NAT in version 8.3?The config i have is from Versi...

OK thanks.Do you have a link to a design document on the best setup for them

I have 2 Cisco WS-CBS3020-HPQ blade switches in the server farm and each one has a seperate trunk li...

I am going to lab it this week.I will let you know many thanks

Hi We have 2 new sites which each have a 40mb connection into the MPLS and are connected together by...

It works fine Richard.I was just getting my source/ destinations mixed up.

Extended IP access list METERS_IN10 permit ip 10.123.232.0 0.0.0.255 host 10.213.234.1

I need to set up an access list on our core switch so that one BMS server with IP address 10.123.234...

Is it possible to have a switch/ router configured for a 2 x Tacacs servers in different locations. ...

We have a site (UK) which has 10 users connecting to the network through a 10mbps MPLS. There are al...