Hi, I am getting many radio resets on 1252AG access point on Wism1. The warning in WLC shows as : AP's Interface:0(802.11b) Operation State Up: Base Radio MAC:c4:71:fe:5c:xxxx Cause=Reset on transmit completion. Status:NAcause = reset on transmit co...
Hi, Is it possible to connect directional antenna on slot 1 5Ghz radio on the 1522SB and use it for client access ? As per the deployment guide there is a note that Omni antenna is required on slot1. If i connect directional antenna on slot 1(how wi...
Hi, 1. ) Is it possible to use the PoE port and the fiber port of the 1552 at the same time to provide dual uplinks ? 2) If not, can i use the PoE port just to power the AP and use the fiber uplink for data connectivity ? regardsJoe
hi All, I have a head quarters with two WLC5508 anchored to another 5508 on the DMZ. Now we want to roll out wireless guest to the branches with local switching of guest wireless traffic. The guest ssid used at head quarters is anchored to the guest...
hi All, I am trying to install AC3.1 on windows7 64-bit. But i get the error installation ended prematurely without any reasons for failure. I posted the errors here. I tried installing AC3.0 on windows xp and i get same problem. NAM is not getting ...
hi Dario,
Did you find a solution for this ? Please let me know. Cisco outdoor AP's even the new 1572 range is pathetic in the -E regulatory domain.
regards
Joe
hi Frank, Did vmware HA work for you with ACS5.4 ? does that mean we need to only buy one CSACS VM instance and do vmware HA in order to get redundancy ? Appreciate your inputsregardsJoe
Thanks. 7.0.240 is pretty new... so that means i think it will still be the case with newer codes or 5508 also... has anybody tested this ? my customer has aruba setup and they are experiencing issue where even if RAP loses connectivity to controller...
hi Imediavilla, sorry for repeating the question. if the AP is not able to associate to the WLC, how come you are able to change the AP mode throught WCS ? you can configure mesh AP's through WCS only if they are associated to WLC, right ?also how...
yes agreed. but what is the problem exactly stated in the intital post ? the RAP if it loses its ethernet is changing to a MAP, and since there was no mac filter added for that in the WLC, it was not able to join the WLC as a MAP ? but i would like t...