Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
narainarun
‎08-18-2017
Beginner
Recent Badges
Awards
Recent Badges
See all
1 Accepted Solution
1 Helpful Vote
10 Helpful Vote
20 Replies
10 Replies
5 Replies
Stats
Member since ‎08-13-2010
66
Posts
24
Helpful
3
Solutions

Re: VPLS over Carrier Supporting Carrier MPLS VPN

Created by in MPLS
11-10-2010
11-10-2010
Hi giuseppe,Thanks for your valuable suggestions. I didnt think about point to multipoint LSP and le...

VPLS over Carrier Supporting Carrier MPLS VPN

Created by in MPLS
10-29-2010
10-29-2010
Hi All,I would like to get a clarification from all whether the following topology and my thinking a...

Re: VPLS Implementation - Need some inputs

Created by in MPLS
09-14-2010
09-14-2010
Hi,Thanks for your replies and it provided very useful information. I had no other choice but to use...

ME 3400 and VTP

Created by in Switching
09-14-2010
09-14-2010
Hi All,We purchased ME 3400 switch and trying to implement it. But its quite surprising in the ME340...

Re: Anything like performance routing available for L2?

Created by in Switching
09-09-2010
09-09-2010
Hi Paul,Its a good thinking of having performance routing in L2 but I am not sure whether its there....

Re: VPLS Implementation - Need some inputs

Created by in MPLS
09-08-2010
09-08-2010
HiThanks for your response. L2 Protocol tunneling will happen on PE routers. But in my scenario the ...

Re: Pass non-ip traffic over ethernet

Created by in Switching
09-08-2010
09-08-2010
Hi Eddie,I assume that you only have access to two 2801 routers at each side of the location and the...

VPLS Implementation - Need some inputs

Created by in MPLS
09-08-2010
09-08-2010
Hi All,We are planning to roll out VPLS services in our network and I need advice from people who ha...

Re: Limiting bandwidth on the CE

Created by in Other Service Provider Subjects
09-08-2010
09-08-2010
Hi,You can define CAR or policing using MQC and apply it on the internet sub-interface in the CE rou...

Re: high cpu only when traffic is high

Created by in Routing
09-07-2010
09-07-2010
Hi Guiseppe,Thanks for your feedback.The router is running "c7200-adventerprisek9-mz.122-33.SRC6.bin...

high cpu only when traffic is high

Created by in Routing
09-07-2010
09-07-2010
Hi,I am facing a weird problem in 7206VXR-NPEG1 router. The router has a STM1 interface to WAN facin...

Re: 2801 throttles problem

Created by in Routing
08-24-2010
08-24-2010
Hi,In the "show interfaces" output do you see any other counters increasing along with throttles lik...

Re: Uplinkfast

Created by in Switching
08-23-2010
08-23-2010
Hi Jingyi,I will try my best to explain why uplink is not recommended (its not that cannot be used) ...

Re: How to do L2TPv3 redundancy

Created by in Routing
08-23-2010
08-23-2010
Hi,You can manipulate the port cost under the interfaces in switch with interface fax/xspanning-tree...

Re: How to do L2TPv3 redundancy

Created by in Routing
08-23-2010
08-23-2010
Hi,I think you can extend the same VLAN to your redundant routers and tweak with STP parameters to m...
Public Statistics
Date Registered ‎08-13-2010 08:17 PM
Date Last Visited ‎08-18-2017 04:03 AM
Total Messages Posted 66
Total Helpful Votes Received 24
Helpful Votes From