HiI'm having problems with a Cisco 2951 ISR when users connect to a VPN service through Open VPN the CPU throttles at 99% and is only lowered when the router is being manually reloaded.
I have not enough knowledge about IOS the know where to begin, ...
HiSo to begin with, I'm no expert in any way, so please bear with me if my conclusions are not based on anything else then a few of my tests, and may therefore be inaccurate to anything outside my network configuration.
I've been conducting a few te...
I'm not used to the Small Buisness switches from Cisco but i currently setting up a SG-500 switch and added mrtg for this switch, and there are so many interfaces, how come?http://mrtg.obscured.se/test/Is there a way to disable all the wierd interfac...
I've been looking (but not finding) for information about if there's any SNMP OID for DHCP Statistics as Leases on a DHCP Pool and/or total leases for all DHCP Pools. And if there are any general statistics about the DHCP in the router?Can't seem to ...
I'm having problem adding access to a NAS inside my network and I can't seem to understand why.ip nat inside source list 1 interface GigabitEthernet0/0 overloadip nat inside source list 103 interface GigabitEthernet0/0 overloadaccess-list 1 permit 10...
So I called our ISP and they went trough my connection and it seeams that they've been blocking 445 the whole time even tough I called them 5 times allready asking the same questions.Thanks for all replys and sorry for the mess made by my ISP.
I've tested all sugested propositions but with no success, I've tried another "cheep" router with success so there have to be something I'm missing in the Cisco 1912 Router.I can't see any connection from aserver located at another location to the ro...
Nothing elese then the nat translations that are there before I make a connection atempt and the atempt times out "telnet: Unable to connect to remote host: Connection timed out"gimli#sh ip nat tran | include 10.0.3.3tcp 78.*.*.*:162 10.0.3.3:161...
Ah sorry missed that part, I'm able to telnet the server on port 445 from the router:"gimli#telnet 10.0.3.3 445Trying 10.0.3.3, 445 ... Open"There seems to be no connection in nat trans, but the remote desktop service can be used (3389).gimli#sh ip n...
I'll try to respond to all tip.I'm able to telnet the port from the inside (from the nas) but not from the outside (445). The interface GigabitEthernet0/0 is obtaining ip address from a DHCP (ip address dhcp).I'm able to access the nas from all of my...
