About smartns04

smartns04 · 07-16-2018

Hello, I have the following setup. ITSP <---> CUBE (4321) <---> CUCM. I am on the initial setup and trying to register CUBE with ITSP. However when I give the sip-ua commands i dont see any SIP messages for register. Instead I am getting the follow...

smartns04 · 05-12-2018

Hi all, I have installed a HA pair of 5508 controlled by an The plan is to have a webserver behind the firewall and be accessible from the internet. As i am rathern new on FMC can anyone suggest a best practice guideline to create the appropriate ...

smartns04 · 11-08-2017

Hi, Is there a way to set up a bandwidth limitation per session. I don't need a per ip or per user Traffic shaping. What i need is to limit specific type of sessions that are not critical for production ideally on occasions that there is too much t...

smartns04 · 06-16-2016

Hi, Our setup is as follows; 1) Cisco ISE 2) WLC2504 3) Guest SSID Once a user connects to Guest SSID and tries to access a website, the user is redirected to the authentication page of the policy node.We have connected the ISE with our AD and after ...

smartns04 · 05-18-2016

Hi all, I have to similar C819HG-4G-G-K9 routers installed at the sime site. One of the is working fine. The second one is reseting the cellular interface constantly *May 18 10:01:21.907: %LINK-5-CHANGED: Interface Cellular0, changed state to reset...

smartns04 · 07-24-2018

Just to update. I have opened TAC and it seems that you need to create a dial-peer first, for the CCSIP_SPI_CONTROL service to come up and then proceed with the sip-ua configuration.

smartns04 · 07-17-2018

Hi Abhay, I have done that several times but no luck. Regards

smartns04 · 07-17-2018

Hi Nipun, I have used 16.03.06,16.06.04, 16.07.02 which are the recommended and also i think it came with 16.04.02. As per your suggestion i just tried 16.8 but still getting the same debug output. Regards,

smartns04 · 05-24-2018

No seconds. Can you truck this mac address at the switch? Is it coming through the correct path? Do you have any wifi devices in the setup? I suspect some kind of loop or IP misconfiguration

smartns04 · 05-24-2018

#clear arp "INTERFACE" "IP ADDRESS" on your case #clear arp inside 10.0.240.12 Is the record you posted correct? Is this the correct mac and ip?

Member Since	‎05-30-2005 01:05 AM
Date Last Visited	‎11-06-2023 05:37 AM
Posts	64
Total Helpful Votes Received	41

User Statistics

User Activity

No SIP messages to ITSP

Port forward FMC

Bandwidth limitation per session

ISE authentication loop

CELLULAR_MODEM_SKU_MISMATCH

Re: No SIP messages to ITSP

Re: No SIP messages to ITSP

Re: No SIP messages to ITSP

Re: Can't ping outside IP address and not Internet

Re: Can't ping outside IP address and not Internet